Reviving Vannie - Interior Project - Spring & Summer 2015
From our travels during the 1980s. A photo from Wyoming.

One of these days, we will do a full page on Vannie and her history. The best description of Vannie is that this 1975 Dodge Maxivan camper has been a venerated member of the family since 1981. During 10 years of teaching travel vacations, we traveled in Vannie 2-1/2 months of each summer, covering almost all of the western USA, plus a foray into Canada and Vancouver Island. The van was our home away from home and it treated us very, very well.

Several years ago, we made the decision to resurrect Vannie from her slumber and to restore and renew her to her former glory. Every warm weather season we do a bit more to get there. Our mechanic has given the vehicle a thumb's-up, and we look forward to as much enjoyment and adventure as possible in Vannie's golden age.

One of these days, we will do a full page on Vannie and her history. The best description of Vannie is that this 1975 Dodge Maxivan camper has been a venerated member of the family since 1981. During 10 years of teaching travel vacations, we traveled in Vannie 2-1/2 months of each summer, covering almost all of the western USA, plus a foray into Canada and Vancouver Island. The van was our home away from home and it treated us very, very well.

Several years ago, we made the decision to resurrect Vannie from her slumber and to restore and renew her to her former glory. Every warm weather season we do a bit more to get there. Our mechanic has given the vehicle a thumb's-up, and we look forward to as much enjoyment and adventure as possible in Vannie's golden age.

This "before" pic shows a pretty torn apart van, as Wes was investigating how to tackle the refurbishing of the cabinet around the van refrigerator. This view is typical of Vannie's well used interior. The paper-faced masonite paneling was dirty, damaged and ragged. While most of the understructure held up very well (it is redwood), the visible facings and trim really needed replacement.

While the cabinet framing around the sink and refrigerator was very well constructed and square, the rear wall with the step-through folding door was hastily constructed and not that square. Instead of tearing out the wall, Wes decided to build another square wall director in front of the old one. A truism in van construction is that there are very few straight walls in a van. An elaborate design of framing and using plastic lumber cut with kerfs to form the curves, provided the structure for the new wall.

1" thick sheets of rigid foam insulation board were cut and pieced into the openings in the framing.

After the insulation was in place, the entire frame was taped and sealed with metalized duct tape. This work paid off this year in the spring, as the van was noticeably warmer during the cold nights.

The restoration project was largely triggered when we found two full boxes of high-grade bamboo laminate flooring at Habitat for Humanity's ReStore in Bend. Each piece of laminate is 5" wide by five feet long, and the pieces can be interlocked. This material is much higher quality than typical bamboo flooring. The strip of bamboo at the top is 3/32" deep. Cheap bamboo flooring has a wafer-thin layer that is easily damaged. The stuff we had bought was super durable.

This shows the refurbished area around the back hatch door, using the bamboo laminate. The trim for the entire project was either black-stained hemlock or oak. After staining and mounting, the black wood is given a good coat of paste wax. The side trim is a foam cord covered in black vinyl upholstery material.

About halfway through the project. The sink counter was a major undertaking. Removed were the old sinktop, a 20-gallon water storage tank, and some pretty ugly facing and pegboard sliding doors. The interior shelf height was changed to better accommodate new storage boxes. Brown Acacia flooring with a lovely fiddleback grain pattern is used as the backsplash.


This is a closeup of a corner of the sinktop showing the black-stained oak edge with stainless steel screws. The entire top is designed so that it can easily be removed and resurfaced.

A closeup of the black stained oak trim at the corner of the sink counter top. The screws are stainless steel. The entire top is designed so it can be easily replaced with a new surface.

The under sink storage areas were very complicated to design, and took a lot of time to build. There is a double-duty table top mounted on a folding shelf bracket that is both a table and the side cover for the upper storage area.

Note the storage bins with the permanently mounted hinged tops and the latch and cover to the lower storage bin.

While the old van had lots of storage, it lacked readily accessible storage for oft-used items. Now there is lots of useful space.

This is a nice view of the sink counter, backsplash, surrounding bamboo walls and black trim. Note the table/cabinet cover seen folded down into the cover position. The opening in the wall is a wall pocket.

This is a nice view of the sink counter, backsplash, surrounding bamboo walls and black trim. Note the table/cabinet cover seen folded down into the cover position. The opening in the wall is a wall pocket.

Here is a more overhead view of the sink area. We removed the water faucets and electric water pump (more trouble than it's worth). When we travel, we lean on a five-gallon cubitainer place in the right-hand sink, and voila! running water.

Here is a more overhead view of the sink area. We removed the water faucets and electric water pump (more trouble than it's worth). When we travel, we lean on a five-gallon cubitainer place in the right-hand sink, and voila! running water.

A view from the open side doors of the van. The opening on bottom left is to a cubbyhole that houses the camp stove, work gloves, ratchet straps and other often used items.

A view from the open side doors of the van. The opening on bottom left is to a cubbyhole that houses the camp stove, work gloves, ratchet straps and other often used items.

A view of the refrigerator cabinet. The fabric on the front panel is Japanese, and we have had it since day one. Nice to carry over a few things from the old van. Note the opening to the left of the cabinet...

This open storage area was also part of the old van and holds the camping table, fly rod cases and other bulky gear.

There was never enough counter space in the old van for inside meal preparation, especially during bad weather. Going to love having this table!

An ongoing necessity is still web access through Verizon mobile broadband. Having this setup allows Wes to manage the WadaWorks business while out in the wilds.

Can't forget this...

A full season of work on the rear interior. In the future, we will add some shallow shelves, a mirror, accessories and Japanese and fish themed decor.

There are a number of options to replace the old self-stick tile floor. That will come late in the remodeling process.

This has been a most satisfying project to experience. Next year, we will tackle the front interior of the van, including side walls, the headliner, an AV control area, and more. That should be a much easier task! Meanwhile, back to camping and fishing!